Local Reviews
for Romeoville, IL
Our Reviews by City
John M.
Commercial plumbing touchless faucet repair. Solenoid in control board under the sink was stuck open, probably clogged with debris from the water. Changed control with customer supplied part. The control board sends an electrical signal to the valve to open or close the valve, allowing water to flow when the faucet's sensors detect the user's hands.
Brennon E.
Furnace repair. No heat call. Found the inducer motor was the only system working. A furnace inducer motor, also known as a draft inducer motor, removes combustion gases from a furnace and helps the furnace operate. Found pressure switch failed to open. Replaced pressure switch. A furnace pressure switch acts as a safety feature that automatically shuts down the furnace if it detects negative pressure, which indicates that exhaust fumes are not properly venting and could potentially backdraft into the home, protecting against carbon monoxide exposure and preventing dangerous situations. Heating system followed sequence and everything turned on. Noticed blower motor was sluggish to ramp up to speed. Tested capacitor and it was below acceptable range. Replaced blower motor capacitor. Blower motor turns on at normal speed now. Tested. Everything is in accurate working and system is heating the way it should now. Cycled unit 4 times.
Chris S.
Commercial HVAC repair. Found a faulty gas valve. Replaced gas control valve on roof top unit. HVAC heating unit is operating safely now.
John M.
Commercial plumbing repair. Installed customer supplied water filter for drinking fountain and bottle filler.
Pete W.
Water softener service. Reset regeneration cycle from every four days to every six to use less salt, advised customer that they may run out of soft water before regeneration at which point we should reset it to every four days.
Michael M.
Commercial rooftop HVAC systems repair. Replaced (2) Trane control device kits for ignition and control boards and circuits. These boards act as the brain of an HVAC unit. HVAC units are running safely at this time.
Brennon E.
Furnace safety inspection. Cleaned and reset furnace to factory specifications. Tested all electrical and safety controls. Replaced batteries in the thermostat. Cleaned out exhaust pipe and drain. Replaced furnace filter that customer provided. Everything is in adequate working condition. The system is operating and heating as it should at this time. Customer renewed VIP maintenance program. One visit is being used today and they will have cooling season of 2025 prepaid.
Dan K.
Furnace repair and safety inspection. Cleaned and serviced furnace. Tested inducer motor, pressure switches, ignitor, gas valve voltage and pressure, flame sensor, blower motor amperage and capacitor. Inspect thermostat and heat exchanger. Found a faulty inducer motor. The important inducer motor runs a fan which provides air for combustion within a furnace and also pushes the exhaust gases out of the flue. Replaced furnace filter that customer provided. Everything else is in adequate working condition. The system is operating and heating as it should at this time. Customer renewed VIP maintenance program. One visit is being used today and she will have one remaining for 2025 cooling season.
Pete W.
Inspected water softener, found it was bypassed. Opened water to softener and ran through it cycles. Cleaned Venturi. Replaced O-rings in bypass to stop leak. Softener appears to be working fine at this time.
Brennon E.
Furnace maintenance. Cleaned and serviced furnace. Tested inducer motor, pressure switches, flame sensor, ignitor, gas valve voltage, blower motor amperage and capacitor. Checked heat exchanger and thermostat. Blew out drain line. Everything is in accurate working condition. Customer renewed maintenance program. One visit being used today and she will have one more visit in cooling season of 2025.
Michael M.
Install rooftop HVAC unit Hail Guard, designed to prevent damage to the condenser coil of the unit during bad weather.
Pete W.
Furnace repair. Need to rerun exhaust piping. Furnace is running and heating at this time.
John M.
Hose was stuck on lawn faucet, successfully came off when using a few wrenches.
Brennon E.
Furnace repair. New inducer motor wheel is making a buzzing noise. Will get back to custome.
Dan K.
Comercial plumbing service. 1- install customer supplied faucet in front bathroom by conference room. 2- RPZ Water backflow testing. Test and certified 3 backflow’s, file reports with city per state code. 3- remove water softener in basement tie line together 3/4” supply line to basement bathroom. 4- replace 2” ground water pump in basement with new check valve combo shut off valve. And deluxe controller.
Dan K.
Commercial water heating repair. Check heater top element and found it destroyed. Client wanted to replace 50 gallon electrical water heater. Removed old water heater tank and installed new Bradford While water heater to code. Tested and cleaned up work area. Removed old water softener in closet that was not being used any more, cap water lines.
John M.
Replaced lawn faucet.
Pete W.
Commercial washroom plumbing repair. Repaired Sloan Crown series flush valve in first stall of east women’s restroom. Flush valve for toilets in an average U.S. commercial environment last for 10 years.
Dan K.
Certified water backflow test for 16 RPZ preventers. Certified backflow’s operation. Drop reports off at city hall public works building
Pete W.
Replaced energy efficient Bradford White 50 gallon water heater and water softener. Test operation for safe operation. Equipment is working well. Clean up and recycle old equipment.
John M.
Water heater repair. I found the gas valve was set to pilot, moved the knob and the burner lit. Tested operations. Water heater is operating normally.
Pete W.
Commercial water heater service. Removed anode rod, flushed and chlorinated hot water system. Do not use water for drinking or cooking for the next seven days.
Brennon E.
Air conditioner maintenance. Cleaned, washed out and serviced condensing unit. Tested capacitor, contactor, fan motor amperage and compressor amperage. Capacitor was below acceptable range and was replaced using a 45/5. Everything else was in accurate working condition. Customer did not have filter in furnace but one was out in today. Checked refrigerant levels and r410a levels were in accurate efficiency range at this time. Customer renewed annual VIP maintenance program. Customer will have fall 2024 visit and ac visit of 2025 prepaid.
Brennon E.
Air conditioning repair. No ac call, after testing found electrical fault. Capacitor too weak to start compressor. Replaced capacitor using a 35/5 and unit is operating and cooling as it should again at this time.
John M.
Shower value repair. Attempted to drill and chisel out old cartridge because the showers are back to back and customer didn’t want to ruin either shower but the cartridge now won’t seal in the valve. Need to come up with a plan to cut open wall in shower to replace valve.
